Bike handlebar switch designs

Posted on 18 April 2021 by yonetici in Bike Accesories, General, Outdoor, Products, Puch | Comments Off

I’ve made some switch designs which can be used in all kinds of bikes with 22 mm handlebars.

various switch and potentiometer combinations are possible

Puch Magnum Seat Toolbox Lid

Posted on 18 April 2021 by yonetici in Bike Accesories, General, Puch, Vehicles | Comments Off

I have made these three toolbox lid designs a while ago. And i guess it is better to publish them instead of keeping in the computer until they get lost due to a HDD failure 😀

You know those plastic lids are get lost very easily. I’ve got 3 magnums and none of them had a lid on it when i bought them. So I made this lid.

They are modeled to be 3d printed. All three fit the original plastic seat tail part. They are printed and tested. Read more for the STL files.

Pages: 1 2 3 4 5

Puch Moped Electric Conversion

Posted on 23 February 2021 by yonetici in Puch, Vehicles | Comments Off

I always loved mopeds, especially puch mopeds and among all, magnums 😀

Several years ago I bought not one, not two but 3 magnums to restore them. Two of them were rather complete, but the third one was not so complete. So i decided to convert it to electric power. So I made lots of calculations and did a lot of design sketches and later 3d models of them.

Later this design has changed a bit to fit the motor and other parts i bought from the market.

Read for more information and also CAD files for my conversion plates and other parts.

Pages: 1 2

Bike computer with graphics screen

Posted on 22 May 2013 by yonetici in Bicycles, Bike Accesories, Outdoor, Products, Proteus Projects, Puch, Timing, Vehicle Accesories, Vehicles | Comments Off

I’ve designed a complete new hardware & software for the bicycle comp that I’ve published some months ago. This one has a 128X64 monochrome graphics screen instead of the 16×2 character display of the former one.

The product is held on the handlebar by two elastic o-rings

this has got real time clock as well as the temperature sensor like the old one. But all data can either be shown fully digital or two different analog display modes.

Bicycle Computer 16×2 LCD.

Posted on 22 December 2012 by yonetici in Bicycles, Bike Accesories, Outdoor, Products, Proteus Projects, Puch, Timing, Vehicle Accesories, Vehicles | Comments Off

This is a bicycle computer product with 16×2 LCD screen, real time clock, temperature sensor, light sensor, total & trip distance measurement, even a knight rider led display that changes its swing speed according to the bike’s speed. A very fun project.

The prototype made on multiholed prototyping board

Bicycle Handlebar Light.

Posted on 02 December 2012 by yonetici in Bike Accesories, Lighting, Outdoor, Products, Puch, Toys, Vehicle Accesories, Vehicles | 1 Comment

Here is the first complete product project of endtas. It is LED headlight for bicycles. It has got two 1W leds, one with a wide angle and the other with a narrow beam angle lens.

The wide lens is a bit turned towards the ground to light up nearby ahead and the other straight ahead for greater distance lighting.