Filling the Second Design’s Part 2
For this part, I followed a little bit different approach, I didn’t fill it to half full from the start. I’ve placed only one layer to the bottom of it, than a second layer covering both the bottom and also the sides. Wetted these two layers with epoxy until they are completely transparent and continued adding layers one by one and appying pressure to get them wet with epoxy. Added a bit more epoxy for every 2-3 layers.
With the previous mehod, the part was filled with more epoxy and a little bit less fiberglass fabric. With this method, the part is filled with a lot of fiberglass and less epoxy in between the layers.
Users Today : 24
Users Yesterday : 77
Users Last 7 days : 466
Views Today : 90
Views Yesterday : 274
Views Last 7 days : 1682
Total views : 1249919
Who's Online : 0